diff --git a/README_PULSE.md b/README_PULSE.md
index d593480c..66e7c079 100644
--- a/README_PULSE.md
+++ b/README_PULSE.md
@@ -1,10 +1,13 @@
 # forked-daapd and Pulseaudio
+Credit: [Rob Pope](http://robpope.co.uk/blog/post/setting-up-forked-daapd-with-bluetooth)
 
-## Setting up Pulseaudio
+
+## Step 1: Setting up Pulseaudio in system mode with Bluetooth support
 
 If you see a "Connection refused" error when starting forked-daapd, then you
-will probably need to setup Pulseaudio to run in system mode. This means that
-the Pulseaudio daemon will be started during boot and be available to all users.
+will probably need to setup Pulseaudio to run in system mode [1]. This means
+that the Pulseaudio daemon will be started during boot and be available to all
+users.
 
 How to start Pulseaudio depends on your distribution, but in many cases you will
 need to add a pulseaudio.service file to /etc/systemd/system with the following
@@ -23,22 +26,54 @@ ExecStart=/usr/bin/pulseaudio --system --disallow-exit
 WantedBy=multi-user.target
 ```
 
-After you have added the file you can start it with "systemctl start pulseaudio"
-and enable it on boot with "systemctl enable pulseaudio".
+If you want Bluetooth support, you must also configure Pulseaudio to load the
+Bluetooth module. Do this by adding the following to /etc/pulse/system.pa:
+
+```
+### Enable Bluetooth
+.ifexists module-bluetooth-discover.so
+load-module module-bluetooth-discover
+.endif
+```
+
+Now you can:
+- (re)start Pulseaudio with `systemctl restart pulseaudio`
+- enable system mode on boot with `systemctl enable pulseaudio`
+- check that the Bluetooth module is loaded with `pactl list modules short`
 
 
-## Setting up forked-daapd:
+## Step 2: Setting up forked-daapd
 
-Add the forked-daapd user to the pulse-access group:
+Add the user forked-daapd is running as (typically "daapd") to the
+"pulse-access" group:
 
 ```
 adduser daapd pulse-access
 ```
 
+Now (re)start forked-daapd.
 
-## Bluetooth
 
-[TBD]
+## Step 3: Adding a Bluetooth device
 
-(this page is work in progress)
+To connect with the device, run `bluetoothctl` and then:
+
+```
+power on
+agent on
+scan on
+**Note MAC address of BT Speaker**
+pair [MAC address]
+**Type Pin if prompted**
+trust [MAC address]
+connect [MAC address]
+```
+
+Now the speaker should appear in forked-daapd. You can also verify that 
+Pulseaudio has detected the speaker with `pactl list sinks short`.
+
+---
+
+[1] Note that Pulseaudio will warn against system mode. However, in this use
+case it is actually the solution recommended by the [Pulseaudio folks themselves](https://lists.freedesktop.org/archives/pulseaudio-discuss/2016-August/026823.html).