RaspAProuter/README.md

# RaspAProuter


This was inspired since my mother-in-law is using [Calyx Institute](https://calyxinstitute.org/) for the internet and the new hotspot (LineZone2) they have supports USB tethering.

Calyx works where they live and my father-in-law isn't ready to afford [StarLink](https://www.starlink.com/) (thank you Elon BTW). 

One Line command (use at your own discretion)

```curl https://git.leffler.media/Leffler.Media-LLC/RaspAProuter/raw/branch/master/install.sh | bash```

Removed un-needed items

```apt purge iptables```

***

Install required items

```apt install bridge-utils hostapd firewalld dnsmasq```

***

Add country code to enable wifi

```echo 'country=US' | tee -a /etc/wpa_supplicant/wpa_supplicant.conf```

***

Enable IP Forwarding

```sed -i 's/#net.ipv4.ip_forward=1/net.ipv4.ip_forward=1/g' /etc/sysctl.conf```

***

Find NICs

It's usually safe to assume that eth0 is the on-board NIC | wlan0 is the on-board wifi

```ip a``` to find the NICs

***

Now we create the bridge

```nano /etc/network/interfaces```

    allow-hotplug eth1
    auto eth1
    iface eth1 inet dhcp

    auto eth0
    allow-hotplug eth0
    iface eth0 inet manual

    # automatically connect the wireless interface, but disable it for now
    auto wlan0
    allow-hotplug wlan0
    iface wlan0 inet manual

    # create a bridge with both wired and wireless interfaces
    auto br0
    iface br0 inet static
            address 192.168.5.1
            netmask 255.255.255.0
            bridge_ports eth0 wlan0
            bridge_fd 0
            bridge_stp off

4. It probably wouldn't hurt to reboot now. Hopefully all is working. 

***

Now run ```rfkill list``` to make sure that you see the wifi is ```Soft blocked: no``` on the WLAN interface which will probably be 0

***

Add firewalld rules

    firewall-cmd --zone=home --add-interface=br0
    firewall-cmd --zone=public --add-interface=eth1
    firewall-cmd --zone=public --add-masquerade
    firewall-cmd --zone=home --add-service=dns
    firewall-cmd --zone=home --add-service=dhcp
    firewall-cmd --zone=home --add-service=ssh
    firewall-cmd --zone=public --add-service=ssh
    firewall-cmd --runtime-to-permanent

***

Configure DNS Masq

```sed -i 's/#interface=/interface=br0/g' /etc/dnsmasq.conf```

Find ```dhcp-range``` and make if what you'd like. I did the following

```sed -i 's/#dhcp-range=192.168.0.50,192.168.0.150,12h/dhcp-range=192.168.5.50,192.168.5.150,4h/g'```

***

Time to configure hostapd. File is in repo for example. ```nano /etc/hostapd/hostapd.conf```

Now we need to specify the config for the hostapd daemon

```echo 'DAEMON_CONF="/etc/hostapd/hostapd.conf"' >> etc/default/hostapd```

***

Now we can enable all services

```systemctl enable dnsmasq hostapd```

***

We can can reboot again and hopefully it's going to be working

```reboot```